diy solar

diy solar

Daly BMS 4s 12V250A

waiapasi2006

New Member
Joined
Mar 27, 2021
Messages
51
Hello all.
I purchased this Daly from a member here to build a battery pack. (initially 280Ah, but had to switch to 230Ah) long story.
This Daly didn't come with a manual. I searched as well, but could not find anything pertaining to the numbers below.

Daly BMS specs:
Daly.JPG


What came in the box:

Daly2.JPG


From what I have read and found so far on the forum:

The cable on the far left are the balancing leads and it's to be plugged in here:
Please correct me if I'm wrong.

Daly3.JPG

The temperature sensor is to plugged in here:

Daly4.JPG


Where would these two others go?
I have one labeled monitor and the other is a Bluetooth adapter

Daly5.JPG

On the opposite side of the BMS, there are similar inputs as well.
I read you can connect the wire labeled "monitor"

Daly6.JPG

Your help would greatly be appreciated.
Thank you.
 
I didn't watch the whole video, but I skimmed it and it looks decent
 
So, as I'm researching and finding documents on the forum, I'm going to post the links in this thread.


 
Here is a video I just found. There are some good information in here as well. Most of it has been covered.
He does mention about the two pins that needs to be bridged @ (17:35)

 
Back
Top