Daly BMS alarm and active balancer presets

[onrbikes]

I've got an odd alarm that appeared after I attempted to join Daly WiFi.
"GPS or soft switch turn off MOS"
How do I reset this?

Also in unable to alter any numbers on the active balancer page.
It gets a setting timed or alarm, but I suspect In not allowed to alter these numbers.
Because I have a 24v surely the cut off volt of 64.54v is incorrect.

 

[Daddy Tanuki]

Go to the last page and enable both charge and discharge on that page. Normal pass word is 123456 enter then push button again to set it

 

[onrbikes]

Have tried the a few times, but it never allows to change any numbers on that balance parameter page
It always "times out" even though it's only a few seconds.

 

[Daddy Tanuki]

Have tried the a few times, but it never allows to change any numbers on that balance parameter page
It always "times out" even though it's only a few seconds.

i have seen that happen and when it times out, if I reenter it and hit enter once or twice more it takes. without it in front of me all I can say is that chinese software is janky as can be at times and you got to play with it to make it work.

 

[onrbikes]

Will have another try.
Thnx