diy solar

diy solar

Daly smart bms high current

Farmgirl0527

New Member
Joined
Dec 29, 2019
Messages
83
Been trying to get this resolved with Daly. 48volt 16 cell system the guy is not being responsive at all. My voltage is normal, checked with a meter, but it displays 75 amp current with nothing other than batteries connected. He says recheck the wiring. I have another Daly and it work with same wires fine. Honestly I have lost any faith in Daly. Anyone have this experience?
 
I have the same problem with my DALY 500A and I suspect the charge controller is shot somehow. The current, albeit not connect to load, fluctuates widely in the high 700 range, which triggers the over-current protection and shuts off the discharging. I have two of the same BMS and I'd swapped between the two battery packs but the problem follows the defective BMS.
 
Good luck getting it fixed. Trying to send mine back and the sales guy Kevin,is ignoring my messages
 
Back
Top