burgerking
New Member
So I finally finished my DIY Battery pack with JK BMS (no communication) to my 5KW Deye.
Battery Settings
Assume late afternoon and Solar is producing only 500W of power, while Load is consuming 1000W of power.
Here are my questions:
How to I set Grid Peak Shaving below 1KW?
Why is it that if I uncheck Time Of Use, my Deye will not use Battery to supply power to Load?
I thought that if I disable Time of Use, Deye will assume it will draw power from battery as needed and at full power.
Power refers to Max. discharge power of battery allowed; and once Battery Voltage <51.5V, it will no longer draw power from Battery during the specified timeframe. Is it because I disabled Time Of Use that Deye is not drawing power out of the battery?
Please check if I have issue with Firmware:
Thanks.
Dan
Battery Settings
Assume late afternoon and Solar is producing only 500W of power, while Load is consuming 1000W of power.
Here are my questions:
How to I set Grid Peak Shaving below 1KW?
Why is it that if I uncheck Time Of Use, my Deye will not use Battery to supply power to Load?
I thought that if I disable Time of Use, Deye will assume it will draw power from battery as needed and at full power.
Power refers to Max. discharge power of battery allowed; and once Battery Voltage <51.5V, it will no longer draw power from Battery during the specified timeframe. Is it because I disabled Time Of Use that Deye is not drawing power out of the battery?
Please check if I have issue with Firmware:
Thanks.
Dan
Last edited: