diy solar

diy solar

EcoFlow Delta Pro and transfer switch setup

I have a similar setup with a Growatt and Reliance TS. Works great except for the AFCI/GFCI. It’s more of a step operating procedure for me at this point where I need to reset breaker in main panel when going from Gen to Line.

Apparently Reliance does make a neutral switching kit. I may give it a shot.

 
I just ordered this Reliance manual transfer switch....but I have a minor complication in that my (older) house has two separate breaker boxes and in order to do what I need to do I'll have to wire the transfer circuits to both boxes .... arrrgh....
(and probably all totally out of code I bet....)
 
I am doing the same thing connecting an ecoflow w/extra battery to transfer switch 306A1-eco signal phase 120v only via RV out to switch. but also have another delta pro that i will use the a/c plug from the first pro w/ battery plugged into the 2nd pro's a/c out. is this OK to take advantage of more battery and solar? it wont cause any extra ground that you were talking about..thanks
 
Last edited:
Back
Top