Hello, I have a Growatt SPH4600 inverter with a self-made 200Ah LiFePo4 battery with SEPLOS 200A BMS.
The BMS communicates with the SPH4600 via CAN.
Everything works as expected. Unfortunately, the SPH4600 no longer uses the battery after a full SOC 100% charge.
I noticed that the SEPLOS BMS interrupts charging after 100% SOC.
The charging switch is off.
Only the discharge switch is enabled.
All good so far, only the SPH4600 ignores the battery from this point on.
There is no fault on the inverter! The message in the BMS monitoring: Intermittent power supply waiting.
Can someone help me?
The BMS communicates with the SPH4600 via CAN.
Everything works as expected. Unfortunately, the SPH4600 no longer uses the battery after a full SOC 100% charge.
I noticed that the SEPLOS BMS interrupts charging after 100% SOC.
The charging switch is off.
Only the discharge switch is enabled.
All good so far, only the SPH4600 ignores the battery from this point on.
There is no fault on the inverter! The message in the BMS monitoring: Intermittent power supply waiting.
Can someone help me?