diy solar

diy solar

Manual Top Balance - charging a single cell in a series pack

DerpsyDoodler

Solar Addict
Joined
Jan 10, 2021
Messages
2,247
in much the same way you can drain a single cell, you can also charge a single cell.

Are there any finer details I should be aware of before I attempt to do this? Any advice or suggestions?

I have 2 lower SOC cells. easier to charge them than drain the 6 others.
 
in much the same way you can drain a single cell, you can also charge a single cell.

Are there any finer details I should be aware of before I attempt to do this? Any advice or suggestions?

I have 2 lower SOC cells. easier to charge them than drain the 6 others.
I have done this with one low cell. Make sure there are no loads connected to the BMS and balancing is turned off.
 
I have done this with one low cell. Make sure there are no loads connected to the BMS and balancing is turned off.
I did it yesterday. I did disconnect from the system (turned off contactor) and did disable balancing, as well. Good suggestions.

It went smooth and simple. Had to charge each for about 1/2 hour to bring them in line.
 
Back
Top