About a month ago, thinking I'm not going to be using this van for a while, I turned off the main power switch on the positive battery cable and disconnected the pv cable from my Renogy Rover MPPT. (this may not have been a great idea) After installing some strip lights today, I turned on the main battery switch and reconnected the PV feed to the MPPT. The Rover display fired up like normal, but there is no power at the fuse box, and no power coming from the Rover MPPT load terminal.
The display shows the batteries at 100% and 14.3V, 0.2A from the panels to the batteries, 20V from the panels, no error message, and zero amps from the batteries to the load. All the main fuses and connections are good. I disconnected the battery, load and pv feed cables from the Rover MPPT then reconnected per the manual instructions thinking it just needs a reboot. Still no power from the load terminal. I installed this system myself over the summer and all was working great a few weeks ago before I made the disconnections noted above. What have I done?
Great forum by the way.
My system:
2 100W panels
Renogy 40A MPPT charge controller
2 100A Lifepo4 batteries
Renogy 60A inverter
Renogy 60A B2B charger
The display shows the batteries at 100% and 14.3V, 0.2A from the panels to the batteries, 20V from the panels, no error message, and zero amps from the batteries to the load. All the main fuses and connections are good. I disconnected the battery, load and pv feed cables from the Rover MPPT then reconnected per the manual instructions thinking it just needs a reboot. Still no power from the load terminal. I installed this system myself over the summer and all was working great a few weeks ago before I made the disconnections noted above. What have I done?
Great forum by the way.
My system:
2 100W panels
Renogy 40A MPPT charge controller
2 100A Lifepo4 batteries
Renogy 60A inverter
Renogy 60A B2B charger