carlos1w
Lego Man
- Joined
- Jul 9, 2020
- Messages
- 113
Thello everybody.
There has been a lot of discussion about the need for compression for prismatic Al cells. It seems that the consensus (though not overwhelming) is that some compression is desirable. If that is the case, what are the ways people have done it? I was thinking some plywood on the ends and 4 threaded rods with bolts. What is the recommended compression?
Thanks!
C
There has been a lot of discussion about the need for compression for prismatic Al cells. It seems that the consensus (though not overwhelming) is that some compression is desirable. If that is the case, what are the ways people have done it? I was thinking some plywood on the ends and 4 threaded rods with bolts. What is the recommended compression?
Thanks!
C