Hillbillybuddha
New Member
- Joined
- Sep 9, 2020
- Messages
- 34
Can't figure out how to get the connector/relay to work.
Battery pos to 400amp Class T fuse to Connector (I forget which one but it's the one that I bought from the company that sales the REC BMS in the states) to On/Off switch, to bus bar.
Battery neg to shunt to busbar.
REC BMS wire marked "Relay DCH NO" when cross referenced to the manual is called "main relay normally open" which is the wire the manual says to use to connect to the small red wire on the connector/relay. The small black wire is connected to the load side of the shunt.
How do I get power to my bus bar through the connector?
Battery pos to 400amp Class T fuse to Connector (I forget which one but it's the one that I bought from the company that sales the REC BMS in the states) to On/Off switch, to bus bar.
Battery neg to shunt to busbar.
REC BMS wire marked "Relay DCH NO" when cross referenced to the manual is called "main relay normally open" which is the wire the manual says to use to connect to the small red wire on the connector/relay. The small black wire is connected to the load side of the shunt.
How do I get power to my bus bar through the connector?