ThirdEyeSamuel
New Member
- Joined
- Jul 5, 2021
- Messages
- 18
I'd love to know if there is a way to reset the contactor after the REC bms has disconnected due to low voltage that doesn't include using the REC BMS PC software.
I couldn't get my systems back online after a LVD until I set a new low voltage parameter. The BMS had opened (broken the circuit) the contactor and I saw no other way to reset it other than to program a new lower voltage for the disconnect and then toggle the bms on and off.
And if there isn't a better way then perhaps this can be achieved with the new wifi module so I dont have to plug in my computer to the device?
Note: In addition to the REC Q BMS, im using the Cerbo GX, Victron SmartSolar MPPT and BMV-712 smart battery monitor all linked with CAN and VE.direct cables
I couldn't get my systems back online after a LVD until I set a new low voltage parameter. The BMS had opened (broken the circuit) the contactor and I saw no other way to reset it other than to program a new lower voltage for the disconnect and then toggle the bms on and off.
And if there isn't a better way then perhaps this can be achieved with the new wifi module so I dont have to plug in my computer to the device?
Note: In addition to the REC Q BMS, im using the Cerbo GX, Victron SmartSolar MPPT and BMV-712 smart battery monitor all linked with CAN and VE.direct cables