diy solar

diy solar

Renogy 60A MPPT with BigBattery 24V Mule Settings

-dale

New Member
Joined
Jan 3, 2023
Messages
1
Location
Tucson, AZ
Hi fellow DIYers,

I am looking to see what others are using for charge settings with their Renogy MPPT controllers and 24V BigBattery.

The BMS in my 24V BigBattery Mule went rogue on me and I just received another Mule in the mail today.

I am not certain that my Renogy settings are the cause or not. I ran this system for over a year without any unexpected trouble.

I was using the default LI settings but today I am concerned about reconnecting my solar panels until my charge settings can be verified.

I looked around, a lot, and found THIS thread. Thanks @Dynoman for the settings.

Here is what I have for USER settings:

BatSysVolt: 24V
BatType USER
Capacity: 120 (Is this based on AH of the bank?)
Address: 1
OverVolDsc: 14.5V
ChgLimtVol: 14.1V
EquChgVol: 14.0V
BstChgVol: 14.0V
FltChgVol: 13.6V
BstChgRev: 13.3V
LowVolRev: 11.0V
UndVolWrn: 10.9V
LowVltDsc: 10.5V
LVD Delay: 5S
Equ-Time: 0Min
Bst-Time: 10Min
Equ-Inv: 30D (rover 60 doesn't go to 185 as mentioned in the linked thread)
Temp-Com: 3
L-CON-T: 5MIN
L-CON-V: 5V

Thanks in advance for sharing your input!
 
Last edited:
Back
Top