Turning off the balancing function (Daly 4S 200A Smart BMS w/bluetooth)

[2BZ2Ranch]

How does one turn off the balancing function of the aforementioned BMS?
The ”Parameter” tab on the BT interface only shows a “Charge“ and “Discharge“ switch which I have used. The “Status” screen will show those switches’ status and the “Balance“ switch status (either green (on) or gray (off)) but there isn’t anywhere to actually turn the balance switch on/off.

My “googling skills” are not very good but I’ve read many threads here where folks say to disable balancing (BMS’s passive balancing) specific to adding an active balance board.

I know this will possibly spark a lot of questions from the forum. Still, I would like to know how without wasting anyone’s time.

 

[Sharky722]

Set the balance start voltage to above the hvd

 

[2BZ2Ranch]

Heh, heh, heh,,, well duh!! That should have been an obvious workaround but I couldn’t think outside the box of “Where’s the darn switch?”
Thank you much @Sharky722 !