Bluedog225
Texas
- Joined
- Nov 18, 2019
- Messages
- 2,909
Good afternoon,
I’ve made it back out to my cabin and the 300 watts 12v of solar have been hooked up to the Victron and the battle born 12v 100a for a few days.
PWM Pro 12/24/-30A. Battle Born said the Victron would be programmed for my batteries before shipping. Not sure if that happened in real life.
The manual says a couple of things. “Over voltage (vbat > 15v resp. 30V).” I don’t know what resp 30 means.
The manual also says under troubleshooting: “Check battery voltage. If too high, disconnect the solar module immediately and replace the controller.”
Voltage (while still connected to panels on an overcast day), no load, is 13.7.
I don’t know what to do with this warning light. Any advice on how to interpret this and best next steps appreciated.
Many thanks.
I’ve made it back out to my cabin and the 300 watts 12v of solar have been hooked up to the Victron and the battle born 12v 100a for a few days.
PWM Pro 12/24/-30A. Battle Born said the Victron would be programmed for my batteries before shipping. Not sure if that happened in real life.
I’m getting two green flashing lights. The first indicates charging. Fine. The second indicates over voltage.
The manual says a couple of things. “Over voltage (vbat > 15v resp. 30V).” I don’t know what resp 30 means.
The manual also says under troubleshooting: “Check battery voltage. If too high, disconnect the solar module immediately and replace the controller.”
Voltage (while still connected to panels on an overcast day), no load, is 13.7.
I don’t know what to do with this warning light. Any advice on how to interpret this and best next steps appreciated.
Many thanks.