jimf909

Likewise.

I was clearly not talking about you and your vast stable of non-shitty generators. I was talking about a generic user and his pal Lefty...

Exactly. Dirty generators happen. Why worry? Run that dirty old cheap generator through a battery charger and enjoy crystal clean Blue &...

My experience is that Victron inverters can get grumpy with dirty power from an open frame generator. I had to deploy software settings...

Still under the eaves, though? Any windows or other openings this side of the house? Some houses are pretty well closed off, others are...

Google says three feet

Onan has an AGS system that may be what you need...

I'm not sure if it's been mentioned, but there can't be sources of ignition w/in 10' of a permanent propane tank. It seems the same...

All you need is an ON DELAY TIMER with a NC/NO relay contacts (or external relay). When pump is to be powered on, the delay timer...

Well, you should never have the switch that far from the pump, but the low-pressure-dropout switch will take care of a broken pipe. I'm...

Sorry for not responding sooner. With a 120V Well pump ou have a few options to go, some complicated while others are simple. I have...

This may not be a direct answer to your question. After years connecting generators to inverter/chargers to charge the batteries and...

I assume you will have large junction boxes at both ends of the 150', one at the array, and one at house. At a minimum, you must have...

One other thing you may want to think about is exactly where to place this "shutoff switch". In my situation, the pressure tank is...

There are a bunch of different failure modes that the OP is trying to solve. The dropout-on-low-pressure switch will solve some...

That's correct. This is easily solves the problem of broken pipe, etc. which is my biggest concern. I'll continue looking at other...

Thanks. I'm not concerned about the pump. My issue is that if the pump runs continuously it will drain the batteries creating a low...

That's what I need. If something breaks there needs to be manual intervention to start the pump and fix the problem.

That's awesome. Simplest solution is usually best. One thing to note- if the low pressure cut off is activated you have to go out to...

This is the real solution, use them on all my pumps.