Hello all!
I have purchased eighty K2 Energy Lifepo4 cells (3.2v - 3.7ah) and have a query on the best way to link these together to make a 12 battery. Originally I was going to place them in parallel banks of 20, then link four of these to create one 12v battery, however I have now realised...
Hello all, I am trying to work out what current capacity BMS I will need for the below battery bank configuration? I‘m intending on running a max 2000w inverter off the battery (this is for a portable system that can be removed from my camper van).
Please can anyone tell me what Amperage BMS...
I should have added that each cell is 3.2v (3.7ah) so I am constructing a 12v battery.
I am looking to buy a Victron charge controller so also need advice on which one would be best for this system. Thanks!
Good afternoon all,
I'm after a bit of advice on calculating the correct charge voltage and current for my new build Lifepo4 Battery. I've read too many differing bits of information and I am now really confused!
I have a load of K2 Energy 26650 cells (3.7ah - 11.84wh- data sheet attached)...
Thanks for the advice! I’m hoping to also charge the battery via a split charge relay using the vans alternator, can this ‘charge input’ run into a Victron charge controller too or would this have to be separate somehow?
Many thanks,
Charlie