Recent content by BOBinGA

I have a WZRELB 2500 watt 24v inverter purchased in late 2020 and it is wired just like your YouTube video, so this is not a new problem. I do agree it is a problem, but my question is “How could this problem not have been spotted in the hundreds of “reviews” in the past several years?”. I...

My voltage today peaked just over 80V (that's pretty much the open circuit voltage) and while the batteries were charging, the voltage dropped to just under 70 volts. That's all within the 62V to 92V range you came up with. Again, that indicates that two panels in series is the best idea. I...

Well, the mystery is solved, I think. After running the battery down last night, today I put just two of the 200 watt panels in series to see what would happen. That helped a lot. Here is the power chart for today: Now just the two panels in series give me over 300 watts whereas all three in...

I started with two panels and ran them in both series and parallel at different times. But either way, I was getting only 240 watts. I got the third panel just to get a little more because I was draining the one battery I had at the time and in December, the two panels couldn't keep up with...

To answer your questions first, I have a 200 ft. of 10 AWG cable from panels to Charge controller. I know this is not ideal, but even this long run does not answer why I am not getting the power I expect. I have 3 X 200W panels in parallel for what I thought would get me close to 600 watts at...

I am seeing this too on my system. The current climbs until it reaches a point about 70% of my panels’ full power current rating and then levels off. I have a Epever Tri Ron 3210. I will try to post graphs tomorrow -Bob