PRAYER FOR BOB
The pastor asked if anyone in the congregation would like to express praise for answered prayers……….Brenda stood and walked to the podium.
She said, “I have a praise. Two months ago, my husband, Bob, had a terrible bicycle wreck and his scrotum was...
New member here; been reading and learning a lot.
In the middle of building a new boat, 38 ft power, for cruising Florida, Bahamas and points South.
I will be using 24volt LifePO4 batteries, 800 watt+ solar panels and engine alternator for charging.
Thanks to everyone here that shares their...
This is an article in Professional Boatbuilder magazine by Rod Collins; owner of 'Compass Marine' and the website MarineHowTo.com.
This would also be relevant to the Up In Smoke thread.
https://www.proboat.com/2022/07/solar-charge-controller-failures/
I am planning my solar/alternator charging system for my powerboat.: [ (2) 230 AH 24 volt Lifepo4 batteries, 70- 100amp alternator, approx 1,000 watt pv panels. This will be installed in the summer of 2023.
My question/ observation is the problem of the alternator regulator seeing the output...
Cold solder joint on power supply alligator clip
I was getting ready to use my power supply and pulled the cover off off the alligator clips and found this.
Has anyone have experience / opinions on how to provide an air gap under flexible panels to allow for air flow to underside of panels for cooling.
This is for an installation where weight is an issue so flexible panels are required.
Here is a free calculator for wire size on boats and some good articles about boat electric and other stuff. This is Nigel Calder's site.
They sell courses there but this is free. I am not associated with this site. https://boathowto.com/knowledge-base/
I am looking for information on design and construction of a load dump clamping device for a 24volt marine installation. Or the source for a device to purchase.
I have just started looking into these; I understand they are used in electric autos.
I don't know enough yet to ask the proper...
Here is some interesting information on fire suppression"
This takes you to a link to download a PDF of 'This study aimed to evaluate the use of Pyrotechnically Generated Aerosols in electrical fires.' https://lup.lub.lu.se/student-papers/record/4316533/file/4316537.pdf
I took a piece of plywood and a piece of osb.
I ran water on them for about 1 minute and then blotted them with a paper towel.
The meter probes are about 5/8" apart
“ December 2, 20224:47 PM EST (Reuters) - The United States will impose new duties on imports from some major Chinese solar panel makers after a months-long investigation found they were trying to dodge tariffs by finishing their products in Southeast Asian countries, trade officials said on...