Most reacted posts

Thanks.. mame sens!

Hello! Is it possible that the inverter needs a min oh one hour in boosting before going in float? (see the diagrams in the inverter manual!)

Hello! The battery setting was at 3 and still in boosting mode when the issue happened (red flashing of battery led). ii will try the setting at 2 (agm) on the inverter as you suggested. The charging boost os slighly over the 55.5, but floating is perfect. when the setting of the inverter was...

hello! The inverter is doing well with the surge...it is a 6000 watt with 300% surge capacity. The issue is with the charging mode setup of the inverter.

https://www.amazon.ca/Power-CON120AC3648VDC-Converter-Battery-Charger/dp/B08KKNK4L9 hello! would I be able to use the aims 48 v charger with my 48 v 60 amp renogy battery? and attached it permanently to the battery allong with my sinigeer inverter? Sigineer inverter is set at using main as...

Thanks, can I put the inverter and the battery charger wires together on the battery terminales? Or if theres a Hub that is required?

Thanks a lot! Will try this...?

Amazing! thanks a lot..with this set up...charging will be automatic! ?

https://www.sigineer.com/product/6000-watt-48v-to-110v-220v-dc-to-ac-inverter-charger-for-sump-pump-with-battery-backup/ https://ca.renogy.com/48v-50ah-smart-lithium-iron-phosphate-battery/ As per the spec for the battery: Maximum Charge/Discharge Current: 50A Charge Voltage:54V The...

Hello! Anyone using a 48 v. Sigineer 6000 watt, 240 , invertor to back up a well pump? what battery are you pairing It with? What is your inverter setup (battery type and % voltage)... And what is the wattage requirement of your pump? thanks,

Hello! This morning, the battery is blinking red...this is a picture of the inverter monitor,,,the inverter is on the main...the goal of the system is to back up a well pump in case of electricity outage ...(no Solar) also, when I tried to run the pump only on the battery, the current was not...

Hello! I faced an issue whith a new back up system (combo battery inverter - on main power) for a well pump (1,5 HP, 10 gpm). The well pump is the only load. the inverter was set at 9...cv 50.25, no float...the battery was getting slowly charged no issue...(inverter on main, with priority to...

Hello! What is strange is that at the setting no 1, the inverter was nicely charging the battery at about 50,8 volt...and than, once the battery is full, the voltage of the inverter increase at 57, thus triggering the BMS of the battery. Itnisnlike the inverter was not able to recognize that the...

Hello! i faced another issue whith the new system...the inverter was set at 9...cv 50.25, no float...the battery was getting slowly charged no issue...however, this time, it was the inverter that went in overload. The only item on the system was the well pump...is it possible that it was to much...

Thanks....the power fails for a few hours up to three days...almost monthly..so, not that much...so, agree with slow charging..

Thanks

New set up - back up for well pump I dont known the correct set up for the new inverter charger? inverter: Dc to ac power inverter charger for sump pump. 110 220V Pure Sine APC 6048 www.sigineer.com https://ca.renogy.com/48v-50ah-smart-lithium-iron-phosphate-battery/ As per the spec...