Hi all,
I need some help with choosing the breakers and dc cut off switch and bus bars.
So far I’ve purchased the Growatt 12k inverter, 4 EG4 48volt 100ah batteries. 400 amp t class fuse. 15 amp inline mc4 fuse. 1/0 awg wire. 2 awg wire and PV wire.
2awg wire will run from the batteries to...
Title pretty much says it all. I spoke with Ian at watts24 and he advised the ground/neutral bond screw inside the inverter can be removed when feeding into a main panel, which has a already bonded N/G.
Anyone have experience running the LVX6048 this way. Or have an idea if the screw removal...
Hello Solar Forum,
I have a Growatt 12k with four EG4 batteries in parallel, 48volt system. Same cable lengths and wire gauge from battery to busbars. Equal state of charge on all batteries prior to installation.
After some testing/discharging grid power was connected to recharge the batteries...
I need help with solar setup. So far, I have purchased (4) 300ah 12volt batteries, a shunt, a Growatt 12k inverter from signature solar, and (25) 430W panels. I’m missing breakers, fuses and wires/cables and have no idea what sizes would be required if the inverter was to be utilized to close to...
Title basically says it all. My inverter will experience random voltage drops. But today was something new. On top of cutting off power it had finally spat out a warning/fault code (61). Not much information in the manual on code 61 other than "External MPPT consistent warning". Anyone have any...