Recent content by Doxmia

Did you ever figure out any settings that work for you?

Currently my setup is going into an ANL fuse distribution block where the top is a bus bar and you can install 4 ANL fuses and hookup to the bottom. I've noticed my inverter post on the distribution block gets quite hot while charging making me think the bus bar is a little too undersized for my...

Same issue I am having with my Renogy inverter/charger. I've found the AGM2 profile keeps them topped up but it's basically constantly doing a low amperage charge every 4-5 mins if you have any low amount of draw. The lithium preset makes no sense to have to wait until 12.5V to get a charge...

Just an update: The AGM 2 profile doesn't attempt to charge at full amperage when full anymore but it does do a trickle charge of 4-5amps every 3-4 minutes keeping the voltage > 14.4V it seems (based on my monitor anyway). Not sure if this would be healthy for the batteries or not. Don't have...

I’m thinking of trying the AGM 2 program which is 14.6 boost voltage and 13.7 float voltage. That should work fine, no?

Sorry I am not following you with "Try setting 12v to above the battery voltage". Could you clarify?

Hey guys, new member here - I owe a lot of what I've researched/read to these forums and since after hours of searching and not being able to resolve my issue I figured maybe someone here would be able to guide me. Quick overview of the setup as a whole: 2x206AH SOK Batteries Renogy 3000W...