Hello,
I have been running a single LV2424 for about 3 months and this week added a second unit. I would like to run them in parallel to power to an AC distribution panel in a single phase. They are both set to PAL, with one as slave and one master. Each is connected to 2.2 kilowatts of...
Upon further inspection I have found that the P1 unit is actually read 100 volts on the AC input even though the unit is set to GFD for feed to grid disabled...
Both hots are connected together and hot to neutral it reads 120 volts.
Interestingly I found I can plug them both into the same outlet and it does not pop the breaker immediately, but having them both on the same circuit doesn't deliver the 40 amps I intended.
I recently added a third LV2424 unit to my setup and was attempting to configure the 3 units to supply a single phase.
However, I am having an issue with the 3rd unit. The third unit has been used for battery charging only while I was waiting on a third communication board.
I added the...
Is anyone aware of a off the shelf product which will read the DC battery level and switch on an AC circuit when the DC voltage reaches a specified level? I am exploring using a AC water heater element as a load dump. I have considered DC but the distance from the battery to water heater would...