Most reacted posts

Hello, thank you for your reply. After posting this question, I continued to do some research to evaluate the safety/feasibility of tieing in two inverters to the same AC bus. I've concluded that this is not a good plan. Thank you again FilterGuy.

Hello I realize this thread is a few years old but it seems to have ended abruptly. How did it turn out for you? How to you assure in phase AC? We are seeking to do a similar system with Schneider or Victron but both are advising against it.

Thank you for the confirmation, PVGirl. That helps piece of mind a lot.

Sunshine_eggo, Thanks... you helped a lot. That's what we need for now and if we need more power in the future, this Victron has some up side. Thanks again

Hello All, I haven't posted in awhile so straighten me out if I violate any protocol. I have a Xantrex Freedom 3024 Inverter with a good Lifeline AGM 24VDC battery system. It's been working fine for a long time and I have no complaints with how it manages the DC loads and the 110VAC. The...

Hello, I'm a little new to the Victron line up but we have decided that the 120v/120v Victron 24/3000 would be a good fit for our application. We understand that it is 120v in/120v single output. We have two questions with regard to the feeder for this device. We understand that it is a...

That sounds like a potential cause. Thanks. I will continue to monitor. thanks for the guidance.

Thanks for the replies. According to the Tech Support, there is no way to monitor individual cells - it’s a sealed unit LiFePO. The battery monitoring system in control is a Schneider Conext BMS/Insight and it controls the CC. The 7.5kw battery monitoring is for display only though I get info...

Hello All, I apologize up front if this is trivial but it's bothering my friend and I. I went to his house to look at his newly installed equipment and found that the install company connected his LG panels (370N1K-A6) with Voc of 41.9V and Isc of 10.96A to the P401 Optimizers. All the tech...

Hello, I am new to this forum so this question may have been discussed in the past without me being able to find it. If so, I apologize. I have several systems but one off-grid system has Schneider XW Pro 6948, Context MPPT 100 600, with a Kilovault 48 volt battery set. I received an...

Hello, I need some advice and was hoping someone here could help. I currently have a Xantrex 3024 connected to 24VDC AGM batteries. The Xantrex outputs 120VAC to a panel in a boat. I am adding a larger Context XW+ Pro connected to LiFePO4 batteries to generate 240VAC to now un-backed up...