Well I contacted Atkinson and they sent me the wiring diagram to use with the gscm mini. $225 for the unit plus some connectors, wire and fuses. I could add the battery switch relay, but I will just turn the battery switch on when the solar batteries may be compromised.
I have a champion remote start generator. My inverter charger is a Sun Gold 3000 watt with the Built in green 2 wire auto start port. Can I simply run the 2 wire to the two top pins on the remote/ electric start button, understanding that I would have to leave the battery switch on?
I own this system for my off grid cabin. (Rps 200 with 2- 100 watt panels) I have it connected to the reverse action pressure switch and a 20 gallon pressure tank and use it for all of my water. It is a little finicky in cloudy conditions and the pump will only pump about a gallon a minute...
Thanks. So, if I get a new 100 amp mppt charge controller, am I good on the 100-150 volt limitation with my configuration? Or does that voltage address the battery bank and not the panel output?
I guess I am confused. If each set of panels wired in series put out 10.34 amps x 3 sets=31 amps. Wouldn't that be the maximum amperage the 45 amp charge controller could use?
I have an off grid cabin. I have recently upgraded to a 24 volt 3000 watt inverter charger and added 4 more for a total of six 345 watt solar panels 10.34 amps, 41/ 33.37 volts. I have the panels wired in 3 sets of 2 in series and paralleled in the combiner box with three 15 amp breakers. That...