Most reacted posts

Check your twist lock strain relieved on your eg4 chargeverter. Mine seems not catching the ac cord sleeve properly, exposed wiring and need readjust.

Thanks to point this out ... i tried the AC connect/disconnect when i just received the CV unit. As what you said, need to wait couple of seconds before checking again the Voltage/Amperage settings after AC connect.

Will this one work with 120v ac on the coil drive ? https://a.co/d/cj7iPR2

Hi, I am a new to the all in one inverter + 48v lifepo4 battery. I am currently setting up a EG4 3000EHV-48 with 3x LLv2 battery. have issue with the BMS comms loop and currently working with SS to address this. SS recommend to use USE setting for time being. Inverter Setting: #12 (point back...

This should work as adapter to 120v 5-15 for current chargeverter 14-30P ?

Hi James, I just received the LL v2 battery along with Orange Welded Rack. the handle can be folded out as described but the issue i have is the mounting holes to hold the battery is on the wrong place. There are holes along side but is blocked by the LL v2 battery mounting bracket on both...

or may be this ?

How do you guys manage to get the bus bar replaced ? i try to contact the tech support couple of times only greeted with on hold message for more than an hour. email support also no respond, fill in form on their page also have not got respond.

Yes i can confirm this as well that settings are retained. sometimes i have to click enter couple of times if i doing it too fast after connecting AC, but the setting is back.

Hi, is there an all-in-one (AIO) off-grid to charge server rack 48v battery based on existing solar panels grid-tie setup with AC microinverter ? Currently i have existing solar panels setup for few years back grid tie with AC microinverter. Thinking to add battery, and to use the solar...

Thanks will check and get back.

On another observation. The voltage and amp setting as attach. The actual screen reading during charge. And my clamp said the amp is higher compare to CV the screen.

That is the tought.

i am expecting a delivery for LL2 battery with the provided welded cabinet as part of the FREE. hopefully i don't have same issue with the one posted here ... ?

got to power up that AIO inverter like ~70-80 watt idle usage.

it is good, but unfortunately the setting is not retained on the chargeverter on AC Input disconnect. When i try couple of time connect-disconnect AC input, Voltage value is reset and for amperage sometimes i see 1 Amp, sometimes 2 Amp, other time 4 Amp.