I have a repeater with the same ssid as the router and the esp has connected to the router instead of the repeater. I have specified the bssid instead the ssid and it works fine :)
Hello, I can now confirm it works fine (had to remove the "latest" in the framework section to compile ESP Home.)
If you want to add to the compatibility list I have JK BMS JK-BD6A17S8P with Sofar Solar Hybrid Inverter HYD-5000-ES (Firmware V3.60) in Pylon mode (US5000)
Thanks a lot :)
Hello, there's a compilation error with ESPHome 2023.4.0, because of this modification :
UART ids
Due to uart0 / uart1 / uart2 being defined in some of the platform code ESPHome uses, ESPHome will now disallow these ids from being used in the config. You can simply change them to uart_0 to...
Thanks I did not looked at the code, sorry :(
Maybe the schematic on the github page needs to specify the pinout / colors?
RS485-TTL RS485 RS485-TTL RS232-TTL CAN BUS
┌──────────┐ ┌───────────┐...
I did not buy nor installed anything, so it's not easy to understand.
Your interface interprets RS485 from JK and "translates" it to a Canbus protocol (Pylon 15S as said in the Github page or Goodwe 16s)
Is Goodwe the same as Darfon, General, Alpha or Soltaro ?
Also do I need a wifi connection...
Hello, I have bought a ESP32 Wroom, a DC-DC conversion module (to pull power from the JK switch/screen port), RS485 -> TTL converter, TTL -> CAN converter TJA1050.
Can you confirm pinout ?
From JK BMS with RS485 module Yellow -> A+, White B- and from the RS485 transceiver TX -> ESP32 pin 17, RX...
Yes, and RS485/canbus conversion works fine (updated really often)
Where should I run this command ?
I think it may be WiFi connection too weak. I'll try to move the access point.
If you want to add to the compatibility list I have JK BMS JK-BD6A17S8P with Sofar Solar Hybrid Inverter...
Hello, I have problems with update rate in HA.
Data are retrieved randomly (>20' sometimes), but RS485/CAN conversion is working correctly.
Do you have any idea why ?
Hello i'm still having disconnection issues, but I can't figure out if it's wifi related or anything else.
I don't understand this part, I uploaded the code through Home assistant ESP implementation ?
If I activate the logs in the YAML there's really a lot of things reported so it's difficult...