Most reacted posts

I talked with Eric on Friday and asked him about the l1 to l2 imbalance and he told me that he has one installed @ his home and put 9k on one leg with no problems. He also told me that the xwpro will be made for years to come. I also told him that the xwpro with the BCS and no CLP will need the...

This is a know bug with the eg4 bats. using the bms and SOC. Schneider Electric is going to have new firmware out in the next few days for the fix. The fix I came up with for now is: go into the MPPT config and reset to factory. Re-setup then go into the 6848 and under battery settings turn...

Home Equity Line of Credit. (HELOC). https://www.bankofamerica.com/home-equity/

Just bring an equipment-grounding conductor (EGC) from the main panel with the phase conductors if needed.

Do you have the WattNode?

Setup the HVCC for Negative Array Grounding and only open the positive via the disconnect (HU361RB) and add two spds.

100% Correct! its all in: Soares Book on Grounding and Bonding, NEC-2020.

Do you have a Schneider CC? 60/150, 80/600, 100/600 etc. What firmware is the 6848 running?

Ok, how is the 6848 setup? Do you have a CLP or the BCS? Also what grid-code is the system set for? Enhanced Grid Support is only when used with a CC, just keeps the batt. @ 100% SOC before export.

Then go under: Configuration->Controls->Configurations and disable sell. What is the setup? Do you haver a CLP or just a main panel? Is SOC control enabled?

I was going to install it today and turn on SOC, but I think it's not going to fix the SOC using the BMS with Eg4. Did do this webinar yesterday. Once you have installed the new firmware log into the insight go to setup on the top then on the left BMS setup and under battery type you will now...

Kram, in your screen shot you have the export start @ 8pm to 6pm.

This is what I use. https://www.amazon.com/gp/product/B00ZJIOA40/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1 You can also configure the charge controller to be compatible with either negative-grounded, positive-grounded, or ungrounded (floating) PV arrays. Take Care, Neil

Are you using a RS (Rapid Shutdown)?

Everyone I am in the same situation as you, when you put any of the batteries on #1 (host battery) insight will not see it under devices. Insight will see it, if it's any other ID than one, but then, it only shows one battery (100amps) and I have 6 so you can't charge and discharge all 600...