Most reacted posts

I think I came up with a good solution thanks to post by n2aws. I was able to follow the instructions for setting up Node-Red on an old MacBook Air. I used the instructions to target charge start voltage address 378 on the Modbus and this also lets me adjust for multiple TOU intervals. I set it...

Monday night the batteries still didn't charge. I called and spent more than an hour on the phone with Schneider and still nothing. I finally decided to downgrade the firmware on both the InsightHome and the inverter and restore the factory default settings. Tuesday it still didn't charge so I...

Last night the system still didn't charge. I was checking the debug and noticed that the timer was sending the command that I setup for when to sell repeatedly but when the timer ended it looked like it just stopped so if it missed that one command I don't think it would send it again. I went...

I would agree that something is wrong with 2.04. I know the time was correct all the way up until I rolled back and defaulted everything. Support told me just to do the insight downgrade but I believe the real issue is 2.04 for the inverter

I have an XW Pro 6848 with 60kw of batteries and plan to install a wattnode so that I can charge at night on my EV plan and then cover my loads during peak. The problem is that the batteries won't charge until the voltage drops under the recharge voltage but if I increase this setting it...

I'm afraid to mess with it now that I have it working. Are there any improvements in 2.04 that make it worth going back to 2.04?