Just an update on this. My 4.8 have been adjusted in January. They were all in series so any shading was causing major issues. I’ve now split them into 3 series strings in parallel. I’ve also replaced china inverter for 2 victron smart mppts and victron multiplus 2 5k inverter. Also added...
Hi
I'll keep this basic but can add more to the post if needed. I've got a powmr 6kw inverter and It's powering my garage electrics. I've connected all the earth wires, and it has a 240v feed from the house fuse box. When the battery has power, it will invert the DC and power all my lights and...
Thanks for all the replies guys. I’ve ordered a multi plus 2 5000 and collecting it Monday. I already have a victron shunt and 2 mppt chargers so makes sense to have everything victron
I have a 10mm earth from the house fuse box connected to AC in, on inverter then a 16mm live and 16mm neutral connected to AC in from house fuse box via 50amp breaker
Sorry should have said this is not a roof mounted system, its built on a wooden frame outside my garden! its not an optimal setup by any means but its in place until I get my roof fitted out with solar. Just noticed its very poor in july but june and end august been very good.
I have noticed...
Sorry I was playing about, but the settings u see above are what are now set.
Below is VS settings which i have not changed. The DC shutdown ones are what I would like to set if the battery gets to 46.5V it will switch to AC and then switch back to Inverter mode when at 51V
Also, if I overload...
Hi, any of you guys from UK whats your solar been like this miserable summer so far? I got my solar panels start of July and it's not been great tbh. Only taken 3.1kwh from a 4.8kw system today!
Hi, A bit confused why my inverter won't auto switch when battery is low back to AC!
It's all updated, and I've checked settings using VRM download and upload.
Running 10kwh battery at 48v.
Switch on inverter set to 1 and in VRM it's set to ON (stays on AC input)
Any ideas pls
Hi guys
I have pow mr charger/inverter. 6kw max 500v dc model POW-HVM6 2M-48v
I've just tested the voltage from its PV input mc4 connectors and its outputting 25v, is this normal? this is with all strings disconnected. So when i connect the strings, it must send 25v to the panels. Not sure...
Not sure but its working, Im getting no grid alarm on cerbo now which is annoying. Ive seen some people have a -10w load from grid at all times. Not sure how to set this