Most reacted posts

This is my plan too. I have this generator now and see videos of folks using ST Smart switch to get it to autostart as ChrisG reports.. The contacts on the 6000XP work as youd expect and I am pretty sure this will work and already bought all but the the ST switch. I'll report back when I get...

I finally got somebody at signature solar to tell me it probably has nothing to do with what we want but instead is related to a communication function to take a smart battery out of standby over a serial link.... I was hoping it would apply a voltage and wake a battery up but they don't think...

I don't believe when I unboxed my 6000xp and new eg4 48V WP battery as it was in BMS UV protect. I had to use a pwoer supply set down to 2A Current limit to wake it then all fine. Because if suggestions earlier in this thread related to voltage based discharged settings I updated firmware. I...

I cannot adjust higher than 50V for warning and 49V for EOD and Cutoff. I have not been able to fully figure out constraints on these number but I know this....the sole constraint in manual (range) isnt the only one one as I will try to move them together and cant. There are other unpublished...

I showed no update available when I connected. I cant get to unit at moment and dont see FW on monitor page. Will get ASAP but pretty sure latest.

I have this 48V100AH WP battery that came off the shipping palette in 0V situation so I assume its in BMS protect. Cant Bluetooth to it either. SS thinks unlike other all in ones the 6000XP can be used to wake it up. Id prefer this than trying to use a benchtop power supply or charger...

In process of getting from Current Connected. In mine only the the top 2 run. I also get a fan stuck but not obstruction. CC told me its like 2 for inverter/charger, and one for PV MPPT. When I get pin out I'll loop back here. I have not used mine with PV yet still testing.

First, @Zapper77 love your videos and wanted to thank you for your moving collective knowledge forward. Also, if you answered this in your note to @ChrisG I didnt absorb it so apologies for asking you to repeat yourself. Question: Can you gents make sense unexpected battery shutdown behavior...

I dont see battery warning on LCD or in the list of 29 settgings in the table in the manual. Is this something you can change via LCD? If so where is it?

I only see warning on app and webpage. Neither lets me go above 50. Do you see a away to change this via LCD? Are you able to set higher than 50 by any means? Trying to test your suggestion to add some buffer to the number discharge numbers but cant get warning higher..

ccaa-160B0B

I am but no AC grid input, only gen input.