Most reacted posts

I configured my LCD to be off to save energy what little it consumes, but yes after I turn the power switch to the “off” position the fans continue to run but also my panels are still absorbing some light to create input to the inverter which is keeping it on but I think the fans consume more...

That’s some helpful information. Thank you!

If you connect laptop and view the configurations within watch power is your charge source priority at the correct setting? I’m new to this also, just a stab in the dark.

Thanks Matt Last night I turned off the converter just to have some lights early this morning. I have tried the power saving mode earlier, all that does it limit the amount of AC voltage out for standby. With no draw from the inverter overnight, it still dropped below the low voltage threshold...

Thanks Sunshine Yes 2- 100ah LIFeP04 batteries in series. It’s just past 2:00 here in the Shenandoah Valley and the panels are still in full sunlight. They facing southeast. At around 3:30 - 4:00 they will be out of the direct sun. The batteries are fully charged presently. I had noticed...

Hey folks, new to the forum and to solar generation. I have all new components, MPP LV2424 all in one, 2- 12 volt LiFp04 batteries in series and 3-200w x24v panels. Batteries charge fine through the morning and into the afternoon but at night the batteries discharge and inverter shuts down with...

Will disconnect the batteries tomorrow and check the individual voltage’s. Will report back. Thanks

My thoughts are the same.