Recent content by J_Iu

From your experience, do you think your actual testing 306ah capacity gotten from the 280ah you purchased will remain till the battery lifespan start dropping? I think people that have used similar products for some times now should be able to tell if the capacity has dropped to the original...

Sorry, this was a mistake. The original post is there

From your capacity test results, the 280ah was actually testing 306ah and I want to ask, will the 306ah capacity remain till the battery lifespan start dropping? I was told that if you purchase Grade A 125ah cell for example and the actual testing capacity from the test gives 130ah, it will...

I was surprised because all the cell's qr codes I've been scanning has been given me values for the energy and the capacity. I wanted to know if someone else has experienced this before and also to find out if it was normal or there was a foul play by the seller.

Yes. I scanned them and those were my findings. I was surprised to see the energy recording 0.0wh and the capacity recording 0.0ah

I scanned Eve 160ah cells and all of them have the same results showing the capacity of 0.0ah and energy of 0.0wh Is this normal?

I scanned Eve 160ah cells and all of them have the same results showing the capacity of 0.0ah and energy of 0.0wh Is this normal?

SCANNED EVE QR CODE SHOWING 0.0WH AND 0.0AH Is this normal?

Thanks

Should I reset the calibrating voltage?

No

I went further to check reading of individual cells with multimeter and 10 cells were reading 3.203v each. 4 cells were reading 3.202v each while 2 cells were reading 3.201v each. Total 51.24v. I just installed Victron BMV 712 and I've not set it yet and the reading was 51.21v. I switched on the...

My jk bms is reading 54.36v on my phone but testing each of the wire, everything read correctly, the last reading on the cable was 51.26v as I was testing each wire. I tested the individual cells using multimeter and I got 3.202v What could make the bms on my phone to read 54.36v instead of 51.26v?

My JK bms is reading 54.36v Measuring with multimeter, individual cells read 3.202v. I tested the wiring by measurements , the last one gave 51.26v but when I plug the cables into the Jk bms and start the bms, the app display in my phone is showing 54.36v. What could be the problem?

I forgot my jk bms password