diy solar

diy solar

Most reacted posts

  • Post in thread: Upgrade BMS

    I have 2x SOK 12v206 in series for 24v, BMS rated max discharge 100 Amp, hybrid MPPPT lv2424 is 2400 watts output. When I run 120v tools (panels disconnected but full charge on SOK's) 9 amps (1080w) & below I can get many hours run time. When I go above 10 amps, the batteries BMS opens circuit...
  • Post in thread: Upgrade BMS

    Thanks so much for your time, insight & knowledge !! It has been a privilege to have your support & greatly appreciate the recommendations !! Curious question, the soft start units you referred to earlier, is that a logic controlled / capacitor based smart unit, would be curious to know how...
  • Post in thread: Upgrade BMS

    Greatly appreciate your insights & knowledge !! Thanks for surge vs continuous view as they do bear separate consideration also appreciate your view on SOK / cost as they very much are economy segment. I haven't had a chance to research BMS / specs yet, just thinking find one that's less...
  • Post in thread: Eco-Worthy 12v 280Ah

    Have experience w/ SoK & they're ok w/ some BMS limitations for power tool surge-draw. Curious about Eco-Worthy as their 280Ah 12v unit boasts on 250a BMS but I can get no response to the window (time) of over-discharge it will allow. My app is starting small power tools (10-15 amp) from...
  • Post in thread: Upgrade BMS

    Thanks so much for taking the time !! I'm no sparky so greatly appreciate the math as well & it prompted me to review the manual again & it seems to solidify my thoughts that the discharge protection (BMS) was the kill switch. These SOK's are in the metal cans so I thought if I could get to a...
Back
Top