Most reacted posts

Thanks Arthur, I appreciate it. Jerry

Hello, In my current 12 volt AGM setup I use system buss bars. Everything is connected to them, battery bank, inverter, 2 charge controllers, fuses, shunt and some 12 volt loads. If I have 16 cells 4S4P LiFePO4 with a BMS for each 4S. I'm wondering if there is any reason I could not just hook up...

Hi, I've been looking for a way to flip a switch and view the cell voltage of 4 4S LiFePO4 batteries all at once. All 16 cells. I was thinking maybe 4 of these. Then I found this charger that shows all 4 batteries at once. I would use it just for the display. does anyone have a better...

Thank You, Sorry I misspelled 4S4P. Do I need 4 shunts? The only reason I have one is for my battery monitor. I was thinking that the BMS's with bluetooth would take care of that. Jerry

Can You do this?? I've searched but no luck. Thanks Jerry

I don't under stand, What are these 4 shunts connected to, Is there another piece on hardware needed for the shunts? Sorry, but you need to make it simple. Thanks Jerry

Thank You for your comments, I appreciate the info. That clears things up a bit. I live in my bus so 32deg is not probable. Jerry

Do they all have the same name or address? Your phone only sees one device? Thanks Jerry

Thank You So Much Should the amp rating of the shunt match the BMS? Jerry

Hello Friends, I have been living in my bus for about 15 years. This is where I am now for the winter. I have 8 200 AH 12 volt AGM batteries for 1600 AH. 1580 watts solar, 3000 watt 12 volt ProSine sine wave inverter/120amp charger, 2 outback MX60 charge controllers. My first set of bus...