diy solar

diy solar

Most reacted posts

  • Post in thread: need 24v use 2 12v?

    First, it is an electric mower not an electric start. No gasoline involved. The Mfg told me the motor will draw 'no more than 5 amps' The C rate of headway cells in 25. Room is limited on the mower so a 2p8s battery would be too big by a factor of 2. I would imagine there would be an amp...
  • Post in thread: Let some smoke out of my BMS

    How can I test if my BMS is dead? I got a Daly BMS separate port for the 24v 8s1p battery pack I am building. I wired up the leads per instructions, tested everything per instructions and everything looked good. I made sure nothing was exposed and nothing would short out. The case these are...
  • Post in thread: need 24v use 2 12v?

    Update on my 24v mower. I finished the pack of using 8 38120 headway cells in series. Pack started with 26.4V. Last weekend was not bad for Feb so I got the mower out of of the back of the garage and ran it for 45 minutes. That is about 50% longer than it takes to mow the entire lawn...
  • Post in thread: new to forum and LiFe batteries

    I found this forum from watching Sailing videos on YT. One of them linked to Will's YT videos and I was hooked. Being a life long DIY'er in many areas and a retired Tech Ed teacher, I thought this is a natural fit. I have a sail boat (think floating RV) that is currently using AGM batteries...
  • Post in thread: need 24v use 2 12v?

    I was thinking the same thing about the charger. I could get a dc/dc constant volt amp board and run it through that or just take it to my bench top power supply. I can crank it up to 28v or more. The new LiFe power pack does weigh all that much to taking it to the bench is no big deal. The...
  • Post in thread: Let some smoke out of my BMS

    I win a prize? Well, at least something went right after the smoke clears. What do I get beside holding your beer?
  • Post in thread: need 24v use 2 12v?

    Newcomer here. Just joined 1/7 at 10:25 AM. See that post for details on what I am up to. In short, I am replacing 2 12v SLA batts in series with an some 38120 3.2v cells in 8s1P config. I looked around for a 24V 8s BMS but the only ones I could find were really expensive. Then yesterday I...

diy solar

diy solar
Back
Top