Most reacted posts

Hi Maintman , can you share model , link something to help buying the good one? thx

Thanks for pointing this out. The bus bar issue i will manage it with flexible connections, that is a minor issue The “distribution of the force to the entire surface” as i will calll the need to manage the higher force created by the belly in the center of the cell i intend to manage it with...

Dear all, I intend to use springs of green colour for compression on 12 mm rods as follows: 2 strings of 8 batteries lf280k 6 springs for both packs (2 one side 2 mid and 2 other side) end plates oak of 40 mm thickness ( consider no flex) each spring has the following characteristics - green...

Hi all, Nice to meet you ! I was thinking about this a bit out of the traditional spring / sponge / plywood solution. The pressure resistors commonly found seems to fit the 12 psi measurement and digitalization via arduino board.The rough ideea is to fit them to measure pressure than send it...