diy solar

diy solar

Most reacted threads

  • Wire sizing question

    Afternoon all- I am wanting to double check and ask a question on wire sizing and amperage. currently I have 1-160 w panel on my roof with a 30 amp pwm controller 10guage wire coming in from panels, and going out from controller. I am adding 1 more 160 w panel in series w my existing, also...
  • Batteries on a budget

    Evening all- I currently have 3-27/100 ah flooded batteries from bi mart purchased about 9 months ago. They are not holding up very well. I’m looking to switch, I’ve always had good luck with les schwab rv deep cycles. Any other mild priced battery for a weekender that uses trailer about...
  • Battle born or others, what’s needed?

    I am currently setup with 3 LA batteries in my toyhauler. I am adding more solar and new controller, I know I can change parameters on that for lifpo, what about the built in converter that trailer came with, charging while driving off vehicle? Do say the battle born batteries require a...
  • Nature power inverter won’t run micro

    Hello, new here. I am not new to solar and rv systems but far from an expert. I have a toyhauler that came with a 160 watt panel, 30 amp pwm, I installed a 2000/4000 nature power pure sine wave inverter with 3 100 ah 12v flooded batteries. I know my panel is way under sized, we don’t run...
  • Lifpo4 questions for newbie

    Morning all, I am reading through a lot of your threads on different lifpo batteries and the question came to mind for someone that camps all year in temps from 80-90 degrees and down into the 5-15 degree nights in winter would lifpo be a good choiceor not with the cold temp cutoff? The...
  • mixing solar panels???

    I am adding to my solar on my trailer. I have ordered a 2nd 160 w panel to go with the one I currently have, I also ordered 2-180 w panels to wire to a new mppt controller. can I bypass my current pwm controller and run all 4 panels to my new controller to gain efficiency? I would like to do...
  • To disconnect panels or not?

    Question for you experts- Rule of thumb is to disconnect panels before disconnecting batteries. how is a BMS that disconnects battery in a cold temp situation, over voltage etc any different than disconnecting batteries and leaving panels connected to do a battery swap?
  • Battleborn batteries

    Hi all, I’m looking to switch to Lifpo’s. mom torn between the valence batteries used or new battleborn s. Any suggestion between the 2? I tend to lean towards battleborn because of them being new and warranty. My other question is charging. Most of my charging is with solar and MPPT, what I...

diy solar

diy solar
Back
Top