Most reacted posts

Sweet, merica wire. Thank you. I didn’t even think about finer strands bending better.

Most of the Victron stuff is redundant. I think you should consolidate to sbms specs and not only save money but trouble too. I use an sbms0 and follow Dacian’s forum. The only time I’ve seen ANYONE have problems is when they don’t stay in the sandbox. But if you just trust the Dacus and don’t...

What I would do is set alarms with Siri when I started charging cause sure as shit I would get distracted. I ended up buy an Junsi icharger then using the power supply into junsi when I need for solar bank. And the rest of the time I use solar to junsi for all other cells, lights, tools etc

I use the Dacus on a small 12v system and I’ve been following the Electrodacus forum for bout 2 years. I followed the path the Dacus needs and never had an issue. The only issues I’ve seen on the forum are when someone trying to play outside the Dacus sandbox adding stuff that the Dac already does.

So I was looking at making a better than Anker usbC power bank, for my phones flashlight n stuff. Then I saw Wills Electrodacus review. Well long story short I watched, googled, and have now bought Victron 250 inverter, electrodacus SBMS0 WiFi, dssr20, 4 fortune 25Ah cells. I know the cells are...

Also 100w nrgygo blacked out panel. I’m gonna build an arduino tracker for two 100w panels if they work right too. Cause they look sweet

I need smaller gauge wire for after the inverter. This 8g doesn’t Like bending. It’s fully functional and tested. Just need to tuck cables better. This is the first time I’ve made anything like this. It’s kinda dangerous, I underestimated the power those terminals have. And now I know why they...

I went with 4 25Ah cells from the place Will recommended. What I didn’t know was shipping was $70 from Utah. That was almost as much as the cells

Square d Qo series breakers at Home Depot have dc ratings on the spec sheets I use a 20a for my dssr20 input