kolek's latest activity

A lot depends on time and circumstances as well. I DIY'd my batteries from individual cells, and at the time it was absolutely a...

Circling back on topic then, DIY 16S harness has 16 sensor/charge wires each need to go to on battery. A ground, and the primary...

Ok fair enough. Thanks again.

Again, cannot comment at all on the jk, other than that it isn't mature enough for me.. Can only comment on BMS - inverter...

@houseofancients As always, thank you for your suggestions. (y) Are you recommending based on what you're seeing on the new firmware...

And cell voltages and pack voltages and temperature and charging voltage and much more Here's an limited overview of what is send to...

As I understand it, the main point of the communications is for the JK to be communicating the SoC to the inverter so the inverter can...

Choasnature has a different inverter(Solis) I can tell you for a fact that for deye/sunsynk/sol-ark have definite advantages.. But hey...

Well, unless someone posts something compelling to convince me otherwise, I don't see a reason (at least for me personally) to bother...

Seems proper to me. For me, one bms com advantage would be to alter the charging limits of the scc or genny if one or more bms goes...

I believe its the latest firmware - it's 2024 when I last checked. # Edit

Latest firmware for V15 is V15.11

@chaosnature just to be 100% clear, you're using the new JK BMS with the latest firmware and you're saying you don't yet see a clear...

With my Solis setup it was'nt stopping at the 0% SoC until i decided to stop it way before the lower SoCof 3.32 So now i noticed it...

Yeah I can agree with all that. In my BMS I have SOC drifts where if one cell drops below a certain voltage SOC gets dragged to 15% so...

For me it was compatibility - before the integration, my inverter would not see my batteries - then I realized the protect that came...

Getting back to this comment, is the main point here sending the SoC from the JK to the inverter? Edit: by that I mean, is the main...

As for the new JK .... the protocols are being developed and more and more protocols are being added, however, though i have not used it...

The only flur for me is i am still calibrating after so many days....i believe i will get it right soon. been doing arithmetic and using...

I can only talk about my experience and set up. i have Both the old and the new JKBMS's and even a JBD (not worked on this yet) With...