kromc5's latest activity

After syncing, I read the manual several times, but the feature was not thoroughly explained. I ordered the direct cables that evening...

I have them in every combiner box per string; I put breakers on all the single 6s arrays but wanted to research to research if that is...

Are you using the Midnite surge protectors in the combiner boxes? I guess ideally one 600V DC model per (combined) string?

I found these unistrut mounts on Amazon and decided to test them by laying the panels out just to be sure. I need to cut a small...

Let them rest yesterday and set it to float at 54v this morning, but I must pull apart cell 4. The top bank second picture is in...

I'm also doing that since I'm rewiring the panels. I decided the breakers were too expensive to replace multiple times. Now I have fuses...

I ordered some fuse holders and fuses for my midnite mnpv6 combiner box. Been nervous about having the PV cables direct connected to the...

Right at 60kWh, with these two it will make 6 in total.

60kWh per bank?

I sat with the new banks for some time, watching them charge. The bottom bank had the largest delta in cell volts, no loose screws, and...

I just figured it out, I went to make a test profile and that was replicated across all the controllers. There was a late night firmware...

Hit the first issue with a victron, it's been doing well the past few days. I noticed it was getting close to the full on the watchman...

This is actually 5 smaller kits combined. You probably saw it for sale at SS. Also Wil Prowse was reviewing a different rack system on...

Finally after 18 month I've completed the installation of my DIY off-grid system. It was an incredible amount of work, much much more...

I finished all the final touches on the arrays after dark, It's already over 19kw this morning, so that is not too bad. Going to start...

I'm still installing and working on everything, but this is what it looks like so far.

I finally made another ethernet cable to have the 3rd victron up in vrm. I do not see a way to make separate panels for each one. Does...

That is very nice, I wish the flat land was closer. I would have really liked to have long arrays in that fashion. I do have a flat, but...

Check out my setup. Might not be what you are looking for and it was a lot of work but it is high enough for my Bifacial PVs I...

Yes, I read that as 27.62A, over the official limit of 20A. But assuming you don't connect as reverse polarity, you can go above that...