diy solar

diy solar

Most reacted threads

  • Victron. components

    If I have a Victron Battery Monitor & Victron connect for my laptop is a GX touch or color control redundant ?
  • Van life 12v System, newbie ?

    Van life 12v System. is this system to much to run some synthesizers, drum modules, lap top and a few lights ? the draw on the music equipment is minimal. 1 200 watt panel ,1 100 amp battle born lithium 12 battery. would 50 10 ga wire work to controller/all in one ?
  • lithium ion discharge %

    Hello, Recently a BattleBorn tech helped me program a Victron controller and we set the batteries (2 BB 100AH) alarm @ 20 percent 80% discharge not 100%. Evidently if you discharge a lithium ion to 100% there is a whole process to go through to recharge them which I was unaware of. Another tech...
  • what size solar generator

    plugged in a KWH meter to a small refrigerator 24 hr reading over a week .33 kWh What size solar generator would adequately run this fridge 24/7 ?
  • DIY website

    How do I communicate with an order I have questions about or say something arrives damaged etc.. ?
  • First solar install

    should I secure my panels first w/ ground, conduit into the other components are work components to panels ?
  • Victron 12/1200 Phoenix inverter blinking red & green LED

    Victron 12/1200 Phoenix inverter blinking red & green LED. both green & red blinking. I have ordered a VE direct dongle. Had a AC refrigerator plugged in for 2 weeks all was good. The other night fridge shut off & Inverter lights started blinking. Inverter will not re-boot. Batteries had...
  • Eco Flow stationary panels

    We currently have an EF Delta 2 with 220 watt foldable panels. I am thinking of acquiring 2 200 watt stationary panels VOC of 24.3 each which is under the 500 watt 60 v recommendation. If I add another Delta 2 battery does this change the solar input or it remains the same ? I already have 800...
  • Victron Phoenix 12/1200 inverter

    Victron Phoenix 12/1200 inverter the diagram I have which I got from where I purchased say's to use a 2/0 cable connection from battery to the inverter. I do not see how that cable is going to fit into the inverter + - slots as they are smaller than a 2/0 cable. 800 watts of solar & Victron...

diy solar

diy solar
Back
Top