Recent content by marksrig

This 58.4 volts has been changed by the new firmware out by EG4. Another question of mine.

I have this issue too. Can anyone verify why this clock keeps showing up?

DO NOT ground your panels to the negative PV DO run a ground from the panels back to the main panel ground. This is for not only static build up and fault protection, but will eliminate the AC output from the inverters you're feeling. I had the same thing happen and the manual does warn to only...

It has been a while since I posted and I was able to top balance and tonight I was testing my lower limits of the inverter SOC. I was watching the battery voltage with a volt meter while having a 2000 watt load going. The BMS test said it reached 0% as the inverters said, but I was barely in the...

Care to elaborate for us Will?

I love how threads just die.

Did you mean you would need a 200A main panel and a 100A sub panel? You can't get 200A from a 100A panel. My place has a 200A on the main house with a 100A sub panel in the garage where the inverters are. I would just have to run the A/C output of the inverters over to the Main panel to power...

So I found the flashing 2p1 means there was a battery alarm. Going into BMS_test, i see adress 0 and 2 have gone over voltage and shutdown charging. All addresses show 100% in BMS test. These batteries are new and havent rally had any full cycles on them. PS. So I guess the flashing hexagon...

So I didn't get a call today, but it's probably unnecessary. After sitting under the solar all day with no load, I think the inverters finally stopped charging the batteries. I've been watching the status via my WatchPower app and finally saw both inverters say 100% and no power being delivered...

or a not so good time. I'll put you to work on my solar! LOL

Well I take part of that back. It wont charge when my solar is not putting out enough, but I guess that's an obvious fact.

Ok. Something else since the firmware upgrade. I dont hear the capacitors charge when I turn the first battery on anymore. Before there were several clicks as it loaded the inverters caps. That's gone.

The system is so new I dont hac=ve a before to compare to. I just noticed that it hasnt ever fully charged. Whe I did the USE/USE at 58.4 bulk and 54.4 float, things stopped charging and seemed to be working normal. I've never seen these inverters not charging when in EG4/USE even with all my...

I charged them all to 100% and veriufied 100% with BMS_test. Started everything up and it went to charging them.