Most reacted posts

An update to the post !! I have 8 PV 330w mono 2s4p (in theory aprox 2kw) and 4210AN is working with limited current at 40A (69v * 15A = 1020w). So is working with more than 1kw panels, the condition is not to use more than 80v.

is the same. BN have a big radiator and no display. tnx for reply.

UPDATE to the post.... I added two more panels to my 24v system, 1500w (2s3p 320w/panel). The 4215AN is only drawing 1030w - 40A, the same as before with 4 panel. The difference is when is no sun. So, i think if you dont exceed 80v, the controller is running fine drawing only 1kw from a 1,5kw...

Hello, I have at this moment 4 PV 320w - 2s2p. In full sun i have 1024w and the controller (Epever Tracer 4210AN) is working ok. My system is at 24v. I want to add 2 more panels, that is another 500w in full sun. In total will be 1500w into 4210AN. My question is :: Someone is useing the...

you need a smart meter on inverter GND. or if you have talent you can make your own shunt with arduino.

Yes. Thank you for this link but I read the manual of my controller. (pv max 1560w-24v) My question is if somebody is using the controller at 1500w - 24v

Are you talking about CAN1101[FW27-DFSET_GW02_NEW_210616] ?? Because i have same problem with my Growatt SPH

nice. I'm waiting for your test result.

Hello, Can you tell me about the cable pin configuration between sph and bms ? I have some problems with a sph5000, not recognize the li-ion batteries (GSO-GBP48V)

hello jsolar Did you connect sph with seplos with CAN ? Can you tell me about the cable pin configuration between sph and bms ?

The voltage never exceed 70v. I dont use controller load output, I have an inverter.