Awesome @sunshine_eggo! Now THAT is helpful. Thank you so much 🙏
I assume the VE.Bus from unit 1 to VE.Bus of unit 2 to Cerbo VE.bus (2 total cables, "daisy chained") are 'normal' RJ45 ethernet cables?
Like this: https://www.victronenergy.com/cables/rj45-utp-cable
Hi guys,
I've bought Victron equipment but I find it difficult to figure out how to connect all of them together for communication.
I already asked this question in the Victron community, but all I get is a link to a document with some general information.
So that's not helpful at all.
My...
Thank you. The plus (+) IS at the top and the minus (-) IS at the bottom of the bars. Sorry, you can't see it in this picture.
And the wires are the exact same length and there are no shunts or other fuses or so in between.
How do you charge them independently to be the exact same voltage? Of...
Hi, I have 5 Pylontech US3000 batteries connected parallel. But the LEDS on the front show different values.
The system (2 Growatts SPF5000ES) in parallel mode, charging this bank.
No errors at all.
What's the issue here?
I really like those, but I am in Europe (Spain) and afaik I can't get any EG4 stuff, unless I buy them for example at SS in the US.
But even then. I don't know if they ship it to Europe and IF (big IF) they do, there are ridiculous shipping and import costs.
The thing is that I have these Growatts now almost one year and there have been several occasions that they stopped powering the house. Sometimes an error occurs and then instead of sending grid to the house, it completely stops and it leaved the house powerless. It's pretty frustrating when...
It did the trick. Thank you!
Apparently I have to switch on the Growatts one AFTER the other, while waiting for Growatt 1 tot finish booting. And THEN switch on Growatt 2.
What I did was switching on Growatt 1, and after 2 seconds, switching on Growatt 2.
I will explain below what I did, just...