MKalman's latest activity

Thats what I was thinking, but I read elsewhere that it heats up, should it be in it's own DIN box?

Hi guys, I just want a simple answer. I have an active balancer that has the run leads soldered. I want to solder those leads apart and...

So JBD it is?

Agree. Except for this: Fixed. It works best if it can use the 2 signal BMS assistant or directly connect to the hardware control...

I see, a bit overkill for a small home DIY solar system. I want something simple, clean and reliable (as does everyone) but not...

I see, thank you! What are the best options for BMS then, JBD, JK which failed me, and Cellmate K9?

None of the above

Yes. The two pigtails to the main negative other two to the negative on the battery case. All cell voltages showing properly.

I don’t think I did. I caught it when one of my cells was 2.5V. I’m not going to lose sleep over it but I was pissed. If 2.7 and 2.75...

Basically it looks reiable. I've already ordered the JBD, just looking for something that's bullet proof as my JBD ate the dust last...

Not at all, nothing And balancing works at 3 but I’ll change it It does nothing at 2.75. Victron multiplus sucks more power or...

How hard is it to install an electro Daucus? Is it fairly straightforward like does it have the same little 16 S cable connector as say...

So, I don't know whether or not this is the case. All I know is SRIKO sells a lot of BMS so I doubt their stock is that old. On the...

I am praying this is the case, but it really doesn't look so on my end.

Going back to the JBD BMS which lasted me one year. Serious considered the K9 but not sure how hard it would be to configure

Yes, all the parameters are set up, not just turned on. I'll get a picture as soon as I get back

https://srikobatteries.com/product/jk-smart-active-balance-bms-board-7s-20s-120a-0-6a-balance-current/ This BMS, ordered it, installed...