Most reacted posts

Has anyone had any experience with using a Victron MPPT SCC with a wind turbine? I have a mini clipper/diversion controller to put a load on the wind turbine when the charge controller isn‘t charging the batteries, via over-voltage protection. The tech at midnite solar recommends their own...

Thanks, I’ll look into that one.

Thats an idea, I am in a quite rural area, but I will look into the local auctions

Thanks for the reply. Hmm, back to the drawing board, maybe I’ll have to look into a PWM SCC like Morningstar Tristar.

As the thread title states, I have a Magnum MS4448PAE that is causing nuisance trips with arc fault interrupters on the same leg (L1). For example if I have an arc fault breaker in slot #2 on my panel, and a standard breaker in slot #4 on the panel and a toaster oven connected to breaker #4...

Sold

That's a good point, I'll have to reach out to Magnum/Sensata to see if there are any other versions of the remote panel that support editing frequency shift parameters.

For sale is a 7.5kWh Kilovault HAB 7.5 V2. Asking $4500 obro. BMS lists 177 cycles. Located in northern VT. 51.2 volt LFP.

Yes, current cycle count is up to 200

I have half heartedly been in the market for an oscilloscope for a while. I have never used one, but have had a number of instances where I think an oscilloscope would be useful for diagnosing a problem (how bad is the voltage ripple is my wind turbine after a rectifier and capacitor? how clean...