Hi All,
Hopefully someone more experienced can chime in and tell if I have forgotten anything in my battery swap quest for my RV. I want to go with the 190Ah pack shown on wills site. I already have an onboard converter/charger that is Lithium ready and will switch out the standard BIM on the...
Hi All,
I just bought those 190Ah aluminum cells and almost have it ready to install in my motorhome. I do not think there is a lot of bumping around in a motorhome used on the pavement. I will post a pic up of finished product and how it works.
brian
Hi,
This whole thing fits into a plastic battery box that is padded with 1” closed cell foam on the bottom. Should be pretty vibration free. It is 7.5Wx10.5Lx9H as you see it
brian
Hi,
I am in the process of switching out two LA batteries in my RV (motorhome) to a single 190Ah battery pac built with prismatic cells that Will recommended. I covered the Alternator charging issues by using a DC to DC charger( 20 amp version) and already had a lithium compatible...
TGPB,
Is this balancer installed alongside the normal BMS(with balance leads)? Does that mean two sets of balance leads? Or how does install? Thanks
Brian
Hi,
I am just now getting all the pieces to replace 2 LA with 1 Li in my RV. I currently have a converter/charger capable of Li so have that end covered. The RV came with a BIM installed and I was just going to switch that out to a Li BIM but maybe have been swayed to ditch that altogether and...
OzzyMatt,
I just ordered the same BMS from the same place. Can you confirm that you can use the Bluetooth and LCD display (not at the same time though). Icgogo says I have to choose one or the other. I just ordered all three items, Bluetooth, SOC display, and LCD display because they were...
MBR
So I have everything covered I think, I disabled direct alternator charging and went with dc to dc charger. Since my current onboard charger/converter was lithium able I just moved the jumper over to enable it. Question is reading the literature on the progressive dynamics website (manual...
Hi,
I have these cells and the studs have an allen wrench top to tighten. I just snugged them in good and then use the allen key wrench to hold the stud while I tightened the nut down. If you don’t hold the stud from turning with the nut while tightening the nut you could possibly turn the stud...
Thomas55,
confusing to say the least, I do see some on here say they can change parameters via Bluetooth but others say no. Not a big deal for me, I will just get the LCD version and cable to alter values using PC.
Brian