Recent content by Pattap

I did read, good article i don't think this applies to the issue I'm facing. None of this explains why my BMS outputs higher than the batterie's voltage. I've run some tests today. I've reassembled the pack. What i noticed is that when i put any load on the battery i am able to charge it but...

thanks I'll give it a read

thanks for your responses. That has been happening before I have put the new cell in. The reason was that it seems one of them was charging/discharging much quicker than other and as you mentioned BMS would shut off due to too low/high voltage of that cell. What I don't get is why the voltage...

Hi all. My setup is a 4s lifepo4 280ah with heyo BMS. I had to replace one cell after two years of no issues whatsoever. I have put a new cell in back to the pack in order to charge them to 3.6v so I can top balance. Since I have only a small charger, 6a I thought I'll connect it to my solar...