Most reacted posts

I've bought from these guys on Alibaba....80 x 550W panels and 2 inverters at work, and then a 4kW system for home. Found them to be trustworthy and responsive after the order. Paul Webb Henan Livefun Solar Technology Co., Ltd. Export Dept. Director: Karl Xu Tel/Wechat/Whatsapp: +86...

No, they installed it directly over the wire. But asking through the WhatsApp number gave a pretty quick response.

Does anyone know which of the RJ45 pins the CT meter connects to. I bit the bullet in the end and ran an armoured CAT6 cable down to the garage. Oscilloscope shows a reasonable signal but I can't figure which of the 8RJ45 pins my 2 CT clamp wires need to connect to.....

I am seeing this. I have an R61LK invertor with 5.5kw PV and 12 AGM lead acid batteries (250AH). A couple of days ago Megarevo upgraded online my original firmware from 0.0.16 (yep!) to 1.1.43 and a bunch of problems happened. I use Peak Shift anti-reverse and protected loads on a separate CU...

I was also told on the new release that "Spontaneous Self Consumption" was now allowed when I questioned why it had fed to grid at all if Anti-Reverse was enabled.....and was told this was a more "dynamic" thing now and it can do it anyway. I was confused.

What woudl you like to see? :)

https://www.megarevo.com/productinfo1.html here you go!

Batteries charge to 54V on new firmware, and then spontaneous discharge to grid and go back to 50V, Very frustrating!

I've just installed the R6KL1 which is working fine with protected load wired up through 2nd CU, 250AH of lead acid batteries, and 5.5kW of panels. Currently I can't send power to the grid feed as I have no CT meter (vendor didn't send me one). Does anyone know what CT meter I could use with a...

Yep, single phase and yes, 1000:1 is currently set. I had a firmware upgrade (by Megarevo) last week which provideda whole bunch of new menu's.