I bought them all new and used them for about 1.5y without issues. They work great.
No dents, no scratches. Babied. I have the original boxes they came in for shipping.
Still under the 5y warranty.
Multiplus2 3000VA 48V 120VAC $790
MK3 USB interface $45
Plus shipping.
I am in the central...
There does not seem to be any information I have found on how the EG4 6000XP derates its MPPT output or inverter output with elevated temps. However, my 2 units seem to be doing this since they heat up my garage in Florida to 95F as they run during the day.
I do see that the data it records...
My 2 new 6000XPs are set to charge at 56.2V and 54.0V for float. No battery comm. Firmware is the latest.
They get to 56.2V and then stay there until the sun goes down. They never go to 54V.
It is damaging to the batteries to have them stay at the high V once full. That's why we switch to a...
I am using the "self consumption" mode where priority is PV and battery with grid as a backup. I do not see a way to manually switch to grid when I am on PV/battery (and then back again).
Is the only way to do it by setting the "AC first start and end time" values to non-zeros?
If so, that...
I see this Start Quick Charge button on the webpage and phone app.
No mention of it anywhere in the documentation.
What does it do exactly?
What max current does it use?
I'd rather hear from you than just blindly trying it.
Setup: off-grid Victron 250/60 MPPT, Multiplus 3000W inverter, Trophy 48V/100Ah (installed 11/2022)
Here is my problem --
To keep the inverter from having a “High DC Ripple” alarm and then shutdown, the battery cannot get to a self-reported 100% SOC.
When it does get to 100%, it disconnects...
Hello,
When not using battery communication.....does the 6000XP have a setting to power loads from the grid when the battery SOC gets below some %?
Then, back to battery once the SOC is above some %?
I assume so but do not see this in the manual.
As many of us know, using voltage to define the...